![]() No worries on heat - its a coal-burning fireplace and. The area above the fireplace is the only logical place to locate a television in our living room, and its currently just sitting on top of the mantle (plugged in and functioning but still waiting to be wall-mounted). This whole building was made without a piece of lumber most likely. Our house was built in 1926 using lath and plaster wall construction. The door frames appear to be made of metal - no studs above them. There are concrete ceilinns and concrete floors and then basically all the walls are non loadbearing, with concrete pillars probably hidden deep inside somewhere.Ģ. It's an apartment building built in the late fifties early 60s. In answer to a couple of recurrent questions:ġ. This is a fabulous idea, as I do have access to both sides. Also thank you everyone for your super fast, varies responses. That way you are less likely to crack the plaster when you tighten the nuts. Even better, slip the bolts through a piece of EMT or other tubing that's as long as the wall is thick, and then put some big fender washers under the head and nut. Alternatively, if you have access to both sides of the wall, and a long enough drill bit, mount the board with bolts that go all the way through the wall. Toggles with the longest, widest wings you can find. That will, locally, turn the wall into an impromptu SIP. If the walls are as unsupported as you claim, you can make them rigid in the area where you're attaching things by pumping some expanding urethane foam insulation into the cavity. Wall cabinets are sometimes installed this way because it's so easily undone or adjusted. ![]() Hanging heavy frames on the wall can be tricky, and with all the. This system allows you to easily take down the hangboard and reconsider your wall mount system if necessary. In this DIY video, I’ll show how to hang stuff on plaster and lath walls using a molly bolt. Then simply hook one bevelled strip over the other. Mount the other on the back of the plywood that your hangboard is on, with the bevel down and its toe outward. If you've got access to a saw, you could also rip a couple of strips of wood or plywood or something with a 10 or 15 degree bevel along one edge, and mount one strip on the wall with the bevel up and its toe outward. Stud detector, strong magnet, bradawl etc. That way you are less likely to crack the plaster when you tighten the nuts. To successfully fix to a lath and plaster wall you will need the following tools and products: Timber batten of chosen width and length (3 x 2 or 4 x 2 and around 1.8 2.4m long) Handsaw or chop saw. 2.46K subscribers Subscribe Subscribed Share 17K views 1 year ago How to mount a TV on plaster wall You just need one stud and a magnetic stud finder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |